root/include/linux/platform_data/mtd-nand-pxa3xx.h

/* [<][>][^][v][top][bottom][index][help] */
#ifndef __ASM_ARCH_PXA3XX_NAND_H
#define __ASM_ARCH_PXA3XX_NAND_H

#include <linux/mtd/mtd.h>
#include <linux/mtd/partitions.h>

struct pxa3xx_nand_timing {
        unsigned int    tCH;  /* Enable signal hold time */
        unsigned int    tCS;  /* Enable signal setup time */
        unsigned int    tWH;  /* ND_nWE high duration */
        unsigned int    tWP;  /* ND_nWE pulse time */
        unsigned int    tRH;  /* ND_nRE high duration */
        unsigned int    tRP;  /* ND_nRE pulse width */
        unsigned int    tR;   /* ND_nWE high to ND_nRE low for read */
        unsigned int    tWHR; /* ND_nWE high to ND_nRE low for status read */
        unsigned int    tAR;  /* ND_ALE low to ND_nRE low delay */
};

struct pxa3xx_nand_flash {
        char            *name;
        uint32_t        chip_id;
        unsigned int    page_per_block; /* Pages per block (PG_PER_BLK) */
        unsigned int    page_size;      /* Page size in bytes (PAGE_SZ) */
        unsigned int    flash_width;    /* Width of Flash memory (DWIDTH_M) */
        unsigned int    dfc_width;      /* Width of flash controller(DWIDTH_C) */
        unsigned int    num_blocks;     /* Number of physical blocks in Flash */

        struct pxa3xx_nand_timing *timing;      /* NAND Flash timing */
};

/*
 * Current pxa3xx_nand controller has two chip select which
 * both be workable.
 *
 * Notice should be taken that:
 * When you want to use this feature, you should not enable the
 * keep configuration feature, for two chip select could be
 * attached with different nand chip. The different page size
 * and timing requirement make the keep configuration impossible.
 */

/* The max num of chip select current support */
#define NUM_CHIP_SELECT         (2)
struct pxa3xx_nand_platform_data {

        /* the data flash bus is shared between the Static Memory
         * Controller and the Data Flash Controller,  the arbiter
         * controls the ownership of the bus
         */
        int     enable_arbiter;

        /* allow platform code to keep OBM/bootloader defined NFC config */
        int     keep_config;

        /* indicate how many chip selects will be used */
        int     num_cs;

        /* use an flash-based bad block table */
        bool    flash_bbt;

        /* requested ECC strength and ECC step size */
        int ecc_strength, ecc_step_size;

        const struct mtd_partition              *parts[NUM_CHIP_SELECT];
        unsigned int                            nr_parts[NUM_CHIP_SELECT];

        const struct pxa3xx_nand_flash *        flash;
        size_t                                  num_flash;
};

extern void pxa3xx_set_nand_info(struct pxa3xx_nand_platform_data *info);
#endif /* __ASM_ARCH_PXA3XX_NAND_H */

/* [<][>][^][v][top][bottom][index][help] */